Milling complex - MK-26
Configeration
| Receiving silo with the slide gate | 1 |
| Comminuting- disintegrating machine «Udarnik 26» | 1 |
| Kit of disks with fingers for the Disintegrator | 1 |
| Stand for the control panel of the milling complex | 1 |
| Frame for the disintegrator | 1 |
| loading funnel for the milling complex | 1 |
| Bag filter | 1 |
| Mixing screw (Ø159 mm\1500mm) | 1 |
| Mixing screw (Ø159 mm\3000mm) | 1 |
| Control panel of the milling complex | 1 |
Characteristics
| Unloading crushed material | Снизу |
| Loading source material | Сверху |
| Finger-beat linear speed | 72 pc |
| Finger-beat linear speed | 64 m/s |
| Maximum initial particle size | 15 mm |
| Engine power on a large disk | 15 kw |
| Engine power on a small disk | 11 kw |
| Disk rotation direction | Навстречу |
| Performance | До 4 t/h |
| Disk speed | 3000 rpm |
Receiving silo with the slide gate
The feedstock from the disintegrator goes to the receiving silo and then into the unloading mixing screw.
Comminuting- disintegrating machine «Udarnik 26»
«Udarnik 26» is equipped with two electrical engines, the capacity is 11 and 15 kW and is intended for comminuting a wide range of bulk materials of various origin with hardness index to 7 units by Moos on-scale. The biggest original fraction is under 12 mm and the material moisture is under 6%. The disintegrator mode is an intermittent rating of short duration. After an hour of continuous operation, the disintegrator needs to stop and start again only in an hour.
Kit of disks with fingers for the Disintegrator
Disintegration is based on the free-kick principle. Both disks are rotating in contrary directions and have kicking items on their surfaces which resemble fingers, arranged in 2-4 rows like a circle. The disks are opposing each other so that the fingers of one disk fit the spaces between the fingers of the second disk.
Stand for the control panel of the milling complex
It is a metal construction to support the control panel.
Frame for the disintegrator
It is a supporting structure to install the comminuting-disintegrating machine.
loading funnel for the milling complex
The loading funnel is intended to unload the soft containers like “Big Bag” with dry bulk materials and mixtures of fine and coarse fractions, such as cement, plaster, sand, crushed stone, grains of polystyrene agitating (ПСВ-С (PSV-S)) etc. for their further application in production or feeding into the buffer storage and storage containers. Bags of 400-2000 kg i.e. disposable or reusable soft containers.
Mixing screw (Ø159 mm\1500mm)
The spiral screw conveyor is intended to continuously transport bulk materials with hard spots under 10 mm such as cement, plaster, chalk, recrement, lime powder etc. in various industries.
Mixing screw (Ø159 mm\3000mm)
The spiral screw conveyor is intended to implement continuous horizontal or leaning transportation of bulk materials with hard spots under 10 mm such as cement, plaster, chalk, recrement, lime powder etc. in various industries.
Description
The milling complex is meant for automatic feed of bulk materials, further grinding and unloading the ground fraction. It is applied in agricultural, chemical and food industries as well as in construction. The major benefits are versatility, low-cost feedstock milling, low energy consumption.
